Description
1982-1988 S10/S15 Pickup
Does not fit 4.3 liter engine.
Replaces GM OEM 14031209
This 1982-1988 S10/S15 Battery Tray fits 1982, 1983, 1984, 1985, 1986, 1987, 1988 Chevy or GMC S10 Blazer, S10 Pickup Truck, S15 Jimmy, S15 Pickup Truck.
Rust doesn’t discriminate. It forms on almost every vehicle and on every exterior steel body panel. If you’re vehicle is exposed to salt spray, it’s most likely going to rust even faster, and usually by the time you see bubbles the situation is a lot worse than it appears. A lot of body panels will rust from the inside out, so those paint bubbles are like the tip of the iceberg. Poke it with your finger and all of the sudden you find a hole that goes completely through the panel. There’s also a good chance that the body panel behind or next to the bubbled one is also rusted. Rust is nasty, but we have the body repair panels to help fix your rust problems.
All of our rust replacement body panels are stamped steel. The stamping process starts with a 3D scan of an OEM part which produces an OEM-like fitment. The old panel will need to be cut out so that the new one can be welded in its place.
Each panel has a protective (EDP, Galvanized, etc.) coating for additional corrosion protection. The e-coating leaves a black finish that can be scuffed and painted over. For additional rust protection, we offer ZeroRust which is a rust-inhibiting paint, as well as a selection of undercoating materials.
Whether you need to replace a lower quarter panel, a dog leg, a footwell, or door pillar, we have the parts that you’re looking for. Fix the rust on your vehicle by ordering this 1982-1988 S10/S15 Battery Tray from Raybuck Auto Body Parts today.
Wayne –
One of the bolt holes did not align – I had to modify the hole. The hole for the battery hold-down bolt is round, where it should be square to fit the carriage bolt of the OEM tray.
Shalom –
Does not fit vehicles with 4.3 V6; the drivers side sticks out too far to clear the radiator. The OEM tray on the 4.3 is cut off immediately past the mounting hole, and does not have the diagonal slope. Also the hole for the battery hold-down bolt is round, where it should be square to fit the carriage bolt of the OEM tray.