1984-2001 Jeep Cherokee XJ Front Floor Section, Driver Side

4.00 out of 5 based on 1 customer rating
(1 customer review )
PART#: 0482-221 STARTING AT $79.00

Purchase a 1984-2001 Jeep Cherokee Front Floor Panel Driver Side from Raybuck.

Drain hole is approximately 2 5/8″ in diameter. Does not come with drain plug.

Approximate thickness: 18ga

Dimensions: 18 1/4″W x 30 1/2″H

This front floor pan will fit both the 2 door and 4 door models.
This is the Left side panel. You can find the Right side panel here 0482-222

  • This field is for validation purposes and should be left unchanged.
SKU: 0482-221 Categories: , ,


This 1984-2001 Jeep Cherokee XJ Front Floor Section, Driver Side fits 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001 Jeep Cherokee, Wagoneer.

Most likely you’re looking at this page because the floors in your vehicle were feeling soft, and when you lifted the flooring you noticed that it was the only thing keeping your feet from hitting the ground. Floor pans take a beating from the elements, and tend to trap moisture coming up from the ground as well as moisture dripping off of your boots. The good news is that we have a wide selection of replacement floor panels to help you fix your ride.

All of our replacement floor panels are constructed of heavy gauge stamped steel that meets or exceeds the thickness of the original body panel that it’s replacing. The stamping process starts with a 3D scan of an OEM part, which means that these aftermarket panels will be an exact match to the original part’s shape. Since the panels are an exact match, the old panel will need to be cut out so that the new one can be welded in its place.

Each panel has an EDP coating for additional corrosion protection. The e-coating leaves a black finish that can be scuffed and painted over. For best finishing results we recommend scuffing the e-coat, priming, and then top coating with an automotive grade paint.

Whether you need to replace the the driver side, the passenger side, front or rear, we have the parts that you’re looking for. Replace your rusted floor pans by ordering this 1984-2001 Jeep Cherokee XJ Front Floor Section, Driver Side from Raybuck Auto Body Parts today.

Customer reviews

Rated 4.00 out of 5 stars
1 review
5 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

1 review for 1984-2001 Jeep Cherokee XJ Front Floor Section, Driver Side

  1. 4 out of 5

    Near perfectOnly reason this is not a 5 star is the floor panel was bent upwards around around the large hole stamped in the floor. This caused about a 1/4 of an inch gap up in the left side foot well area.
    Since the rest of the panel lined up near perfectly, I welded the panel into place along the unibody frame rail and transmission tunnel first. Then using a block of wood above the hole and a short piece of 2x4 below the hole (running from the frame rail to the jack point on the rocker panel) tied together with a 1/4 steel cable (double clamped). While stepping down on the the 2x4, I had a assistant place a 3/4 in thick block of wood between the rocker panel and the 2x4. This pulled the panel down enough to close the gap and allow me to weld it into place.
    Other than this, the panel was perfect. :)

    Was this review helpful to you? 1 of 1 people found this review helpful

Add a review

Use one of the allowed file type: jpg,png. The max size allowed is : 4 MB.